|
Post by HMC710 on Jan 9, 2017 12:54:47 GMT -5
Knocked out some 30 cal pistol profiles yesterday and did one in .30 Carbine and just finished a 30 UZI / Slug'r. Going to do a gas gun with a Tokarev gas system for comparison on the 30 UZI.
|
|
|
Post by HMC710 on Jan 21, 2017 23:16:26 GMT -5
The 30 Uzi is the one in the middle. I need to trim the gas tube to fit from Pistol to LTP length. One on the bottom is the 10mm and I cut it soooooo long ago its got the old Tok gas system on it.....
|
|
|
Post by HMC710 on Jan 22, 2017 12:29:57 GMT -5
Got the 30 DIUZI assembled and ready for testing. Unfortunately I have to go knock out a small field job and then go watch football and consume adult beverages....
|
|
|
Post by HMC710 on Jan 28, 2017 8:49:14 GMT -5
Tested the DI 30 Uzi and I can get it to open the bolt, but that was it. I had a light buffer with std spring set up. I didn't have a top load in it but it was close. When I get back to the shop we will play with the load and set up a bit plus might try some Autocomp powder. That stuff is funny to work with, but it does generate some gas. Got some nose up jams running out of a Tok mag set up, so this is a spare time project.
|
|
|
Post by paulsblackrifles on Jan 28, 2017 15:15:17 GMT -5
I have gone so far as to take all the weights out of a buffer to get light loads to work. Both in a 300 Blackout subsonic and in a light load only 7" .223 pistol. The light load .223 with a can is real low noise. That load is 2400 I think.
|
|
|
Post by HMC710 on Jan 29, 2017 11:48:02 GMT -5
Yep, I have a few standard set ups. Std, Light, and Light/light for testing. We'll run through everything when back at the shop.
|
|
|
Post by HMC710 on Aug 10, 2017 22:53:01 GMT -5
Got the DI 30 Uzi out of moth balls today. will work on some new loads with the new Tok Mag set ups. We out performed the Tokarev with our pistol set ups so this should be easy.....
|
|